beautypg.com

Maintenance & repair instructions, Air filter maintenance, Spark arrestor maintenance – MTD BCR4 User Manual

Page 17

background image

AIR FILTER MAINTENANCE

WARNING: To avoid serious personal injury,
always turn off your trimmer and allow it to
cool before you clean or maintain it.

Clean and re-oil the air filter every 10 hours of
operation. It is an important item to maintain. Failure
to maintain the air filter will

VOID the warranty.

1. Remove the air filter cover by pulling up the two

tabs on the bottom back of the cover, then pull out
and up. See Figure 20.

2. Remove the air filter.
3. Wash the filter in detergent and water. Rinse the

filter thoroughly and allow it to dry.

4. Apply enough clean SAE 30 motor oil to lightly

coat the filter. See Figure 21.

5. Squeeze the filter to spread and remove excess oil.

See Figure 21.

MAINTENANCE & REPAIR INSTRUCTIONS

17

6. Reinstall the filter. See Figure 22.

Air Filter

Choke

Lever

Air Filter Cover

Tab

Slots

Back Plate

FIGURE 20

FIGURE 21

FIGURE 22

Muffler

Spark Arrestor

SPARK ARRESTOR MAINTENANCE

1. Remove the muffler cover. Refer to the Rocker

Arm section.

2. Using a pair of pliers, remove the clip wrapped

tight around the spark arrestor screen. See
Figure 23.

3. Remove the spark arrestor screen from the

muffler.

4. Clean the spark arrestor screen with a wire brush,

or replace it.

5. Reinstall the spark arrestor screen, clip, muffler

cover and screws.

FIGURE 23

Clip