Philips Magnavox VRZ342AT - Manual (Page 9)

Hookups With a Cable Box / Direct Broadcast System (cont’d) 9
With this connection:
● You may watch one channel while recording another.
● You may not record scrambled channels.
Recording One Channel/Watching Another
1
Put the Cable Box/DBS on the same channel as the VCR’s
CH3/CH4 switch. Then, with the VCR in VCR position (the VCR
light will appear on the display panel), use the CH(annel) o/p
buttons to select the channel you want to record at the
VCR. Start the recording.
2
Press the VCR/TV button once to put the VCR in TV
position. (The VCR light will disappear.)
3
Set the TV to the Cable Box/DBS output channel (03 or
04).
4
Select the channel you want to watch at the Cable
Box/DBS.
• When you play a tape, make sure
the Cable Box/DBS is set to the
same channel as the CH3/CH4
switch on the VCR. Set the TV to
the Cable Box/DBS output channel
(03 or 04).
Helpful Hint
1
Connect a Cable signal to the VCR’s ANT(enna) IN Jack.
2
Use an RF coaxial cable (supplied) to connect the OUT Jack on
the VCR to the IN Jack on the Cable Box/DBS.
3
Use a second RF coaxial cable to connect the OUT Jack on the
Cable Box/DBS to the ANTENNA IN Jack on the TV.
Connections
VIDEO
IN OUT
CH3 CH4
AUDIO
OUT
IN
ANT
IN
OUT
75 ⍀
ANT /
CABLE
TV’s ANTENNA
IN Jack
Cable Box/DBS
VCR 1
2
3
Cable
Signal
RF coaxial
cable
RF coaxial
cable
VRZ342comb.QX33 4/7/99 10:06 PM Page 9