Matsushita CF-30CTQAZBM - Manual (Page 35)

9-13
Q Assembly of LCD Unit
9.2.4. Setting the LCD Rear Cabinet, Hinge L and R
1. Fix the Hinge L and R using the 2 Screws.
2. Set the LCD Latch.
3. Fix the LCD Rear Cabinet using the 4 Screws. No1 to
No4
4. Fix the left and right LCD Cover Side Cover using the 4
Screws and 2 Screws.
5. Fix the 2 Wireless Antenna Corner Cover using the 4
Screws.
Note:
Tighten the Screws in the numbered order (No1 to No4).
Screws : DRHM5054XA
Screws : DRSB26+10HKL
Screws : DRSB4+10FKL
Screws : DRYN4+J10KLT
Attach the TS Controller
Attach the Inverter MIL Shierd
0 0.5mm
LCD Front Ass’y
LCD Drop Holder Insertion
LCD Drop Holder Insertion
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Confirm that the LCD
Cushion is not wrapped.
Match to the LCD
edge and attach it.
Clearance : 2 mm or less
1. Insert the TS Flex into the TS Controller, and attach the tape.
2. Remove the Release Paper A and attach the TS Controller.
(Do not come off the sheet and apply the pressure on the LCD.)
3. Remove the Release Paper B and attach it on the TS Controller.
4. Remove the Release Paper C and attach it on the LCD.
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm
* Notes:
Flex Stiffening Plate Edge
TS Flex Insertion
Attach the Tape
Release Paper A
Release Paper B
Release Paper C
LCD Latch
LCD Rear Cabinet
Wireless Antenna
Corner Cover
left LCD Cover
Side Cover
right LCD Cover
Side Cover
Wireless Antenna
Corner Cover
LCD Front Cabinet
Hinge L
Hinge R
No.1
No.2
No.4
No.3