Connecting a dtv receiver, Dtv receiver with component video connections, Recommended) – MITSUBISHI ELECTRIC LT-2220/LT-3020 User Manual

Page 19: Figure 11)

Connecting a DTV Receiver

DTV Receiver with Component

Video Connections

(Recommended)

(Figure 11)

1. Connect the outside antenna cable, or satellite to

ANT or SATELLITE IN on the DTV receiver

(see your DTV receiver owner’s guide for

instructions and cable compatibility).

2. If your DTV receiver has a built-in terrestrial tuner,

connect the incoming terrestrial antenna to ANT

on the DTV receiver. If your DTV receiver does

not have a built-in terrestrial tuner, this TV will

only be able to provide an analog signal through

ANT on the TV side panel.

3. Connect the RCA-type cables from the DTV

receiver outputs to the TV side panel. Component

(1 or 2) may be used for 480i, 480p, 720p or 1080i

components.

4. Connect the L (left) and R (right) audio cables

from the DTV receiver to DTV AUDIO on the

TV back panel.

5. To utilize the benefits of a digital A/V receiver,

connect your DTV receiver’s digital audio out to a

digital input on your digital A/V receiver.

See Appendix B, page 58 for component video

signal compatibility information.

For digital audio connections, see your DTV

receiver and A/V receiver Owner’s Guides.

Figure 11. Connecting the DTV receiver with

component Video Connections.

Note: The TV side panel and connections shown here are for reference only and may vary by model.

��

�

� ��

�

��

��
��

��

�

��

�

��

�

��

�

� ��

�

LCD Monitor 5 8 03.indd

5/8/2003, 3:02 PM