McIntosh C200 - Manual (Page 21)

21
Figure 19
Figure 18
Figure 21
Figure 20
Figure 22
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the BALANCE Control Knob until the words
PASSTHRU OFF appears. Refer to figure 18.
3. Rotate the LISTEN Switch Knob until AU2 is dis-
played. Refer to figure 19.
4. Press the SETUP Push-button to exit the Setup Mode.
Remote Control Selection
There are two choices for the Remote Control Codes that
the C200 will respond to. The Remote Control that came
with the C200 utilizes the NORMal McIntosh Control
Codes. The Second Set of Control Codes that the C200 will
respond to is referred to as the ALTernate Codes.
Note: If the ALT Remote Control Code is selected, the C200
will not respond using the supplied McIntosh Remote
Control.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the BALANCE Control Knob until the words
REMOTE NORM appears. Refer to figure 20.
3. Rotate the LISTEN Switch Knob and select the RE-
MOTE ALT setting. Refer to figure 21.
4. Press the SETUP Push-button to exit the Setup Mode.
Firmware Version
The C200 functionality is controlled by internal software
that is know as Firmware. The Version of the Firmware in
the C200 can be identified at any time by utilizing the
Setup Mode.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the BALANCE Control Knob until the word
VERSION _. _ _ appears. Refer to figure 22.
3. The number after the word VERSION is the Firmware
number.
4. Press the SETUP Push-button to exit the Setup Mode.
Setup, con’t