Motorola S803 - Manual (Page 28)

28 Advanced Base Settings
3. Press P and , to select Yes or No .
4. Select Yes and press P to enter the registration
procedure as below:
1. Place the unregistered cordless handset on the
charger.
2. Press and hold v for 4 seconds on base.
3. Release v once IN USE LED is flashing.
4. A confirmation tone is generated if registration is
successful. Handset X is displayed where X denotes the
number of handsets and the phone goes back to idle.
7. Advanced Base Settings
7.1 Set the Dial Mode
The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press
P and , to select Setup Base .
2. Press P to select Dial Mode .
3. Press P and , to select Tone or Pulse .
4. Press P to save.
NOTE
If pulse mode is selected, press * to switch from pulse to
tone dialing temporarily when dialing out. After the call is
ended, the dial mode will change back to pulse.
7.2 Set the Flash Time
The default flash time is 600ms. It is unlikely that you should
need to change this setting unless advised to do so.
1. Press
P and , to select Setup Base .
2. Press P and , to select Flash Time .