Multitech V.90/K56FLEX MT5600ZDXV - Manual (Page 43)

43
User Guide
&T2 Returns Error.
&T3 Starts Local Digital loopback test.
&T4 Responds to remote modem request for Digital
Loopback.
&T5 Ignores remote modem request for Digital Loopback.
&T6 Requests remote Digital Loopback without self-test.
&T7 Requests remote Digital Loopback with self-test.
&T8 Starts Local Analog loop test with self-test.
Command: &V0 View Current Configuration
Values: n/a
Description: Displays the active modem settings.
*Reports the current (active) stored (user) profile. The stored active
profile is not displayed if the NVRAM is not installed or is not operational
as detected by the NVRAM test during reset processing.
Example:
A T&V
ACTIVE PROFILE:
B0 E1 L1 M1 N1 QO T V1 W0 X4 Y0 &C0 &D0 &G2 &J0 &K3 &Q5 &R1 &S0 &T4 &X0 &Y0
S00:002 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:030 S08:002 S09:006
S10:014 S11:255 S12:050 S18:000 S25:005 S26:001 S36:007 S37:000 S38:020 S46:138
S48:007 S95:000
Command: &V1 Display Last Connection Statistics
Values: n/a
Description: Displays the last connection statistics in the following
format (shown with typical results):
TERMINATION REASON...... LINK DISCONNECT or LOCAL REQUEST
Last TX Data Rate ...... 33600 BPS
Highest TX Data Rate ...... 33600 BPS
Last RX Data Rate ...... 28800 BPS
Highest RX Data Rate ...... 28800 BPS
Error Correction Protocol ... LAPM
Data Compression ..... V42Bis
Line Quality ...... 030
Highest SPX RX state ...... 068
Highest SPX TX state ...... 067