Multitech V.90/K56FLEX MT5600ZDXV - Manual (Page 42)

42
Models MT5600ZDX & ZDXV
Command: &Mn Communications Mode
Values: n = 0
Defaults: 0
Description: &M0 Asynchronous mode.
&M1 Reserved—responds ERROR.
*&M0 selects direct asynchronous operation. Note that the command
sequence &M0\N0 selects normal buffered mode, but the command
sequence \N0&M0 selects direct mode. This is because the \N0 command
is analogous to the &Q6 command.
Command: &Qn Asynchronous Communications Mode
Values: n = 0, 5, or 6
Defaults: 5
Description: &Q0 Asynchronous with no data buffering/no error
correction. Same as \N0.
&Q5 Asynchronous with data buffering/error correction.
Same as \N3.
&Q6 Asynchronous with data buffering/no error correc-
tion. Same as \N0.
Command: &Sn Data Set Ready (DSR) Control
Values: n = 0 or 1
Default: 0
Description: &S0 Force DSR ON at all times.
&S1 DSR becomes active after answer tone is detected
(CD), and inactive after carrier tone is lost.
Command: $SBn Serial Baud Rate
(Modem DTE Speed; bps) { zdx only }
Values : n = 300, 1200, 2400, 4800, 9600, 192000, 38400,
57600, 115200 (in bits per second)
Default: 56000
Description: Example: $SB115200. Sets serial baud rate within a
host/server PC to 115,200 bps.
Command: &Tn Test Commands
Values: n = 0, 1, 3, 4, 5, 6, 7 or 8
Default: None
Description: &T0 Abort. Stop any test in progress.
&T1 Starts Local Analog loop test.