Memorex MPH2430 - Manual (Page 22)

21
SETTING THE AREA CODE
This unit does not require any programming of an area code. However, this setting
could be used to add the local area code to numbers that were stored as 7 digits in
the memory and/or 10 digit dialing if required by the local telephone company. Set
as follows:
Press and hold the VOICE MAIL/
MENU button for more than two
seconds; the Ringer Volume setting
will appear in the display.
1
Press the Scroll Down button ❶ ten
times or the Temporary Tone/
button
❷ ; the Area Code setting will appear.
2
1
2
Press the EDIT/FLASH button to
change the setting; the Area Code
setting will blink.
3
Use the Key buttons (0-9) to enter the
three digit area code for your phone
number.
4
When the desired Area Code has
been set, press and hold the SAVE/
RE/PA button for more than two
seconds; a long beep will be heard to
confirm the setting has been saved.
5
You can continue with programming or
press the VOICE MAIL/MENU button
to return to the Standby mode.
6
SET-UP INSTRUCTIONS (CONTINUED)
MPH2430.O/M.QXD 1/29/03 9:12 AM Page 21