Multi-Tech Systems MT3334HD8 - Manual (Page 89)

E AT Command Summary
CommPlete Communications Server 83
Command Values Description
#Vn n = 0 or 1 V.32terbo Handshake
*** #V0 Enable V.32terbo tones in answer mode.
#V1 Disable V.32terbo tones in answer mode.
W In dialing Wait for New Dial Tone
command Causes modem to wait for new dial tone. (X2 or X4
must be selected.)
&Wn n = 0 or 1 Store Configuration
&W0 Store current settings in NVRAM; modem will
load these at power-on or with the ATZ
command instead of reading factory ROM
defaults.
*** &W1 Do not store settings.
Xn n = 0–4 Result Codes and Call Progress Selection
*** X0 Basic result codes (CONNECT only); does not
look for dial tone or busy.
X1 Extended result codes (w/ CONNECT 1200,
CONNECT
2400, etc.); does not look for dial
tone or busy signal.
X2 Extended result codes with NO DIAL TONE;
does not look for busy signal.
X3 Extended result codes with BUSY; does not look
for dial tone.
X4 Extended result codes with NO DIAL TONE
and BUSY.
#Xn n = 0 or 1 Number of XOFF Characters Sent
*** #X0 Single XOFF character sent after buffer is full.
#X1 Multiple XOFF characters sent (one for every
character received after buffer is full).
Yn n = 0 or 1 Long Space Disconnect
*** Y0 Disable sending or responding to long space
break signal on disconnect.
Y1 Enable sending or responding to long space
break signal on disconnect. (Both modems
must have Y1 set.)
Z n/a Modem Reset
Reset modem to default values. Defaults come from
NVRAM if &W0 is set, from ROM if &W1 is set.
, In dial Dialing Pause
command Comma; causes dialing pause for time set by S8.
: At end of dial
command Continuous Redial
Colon; causes continuous redial of number until
answered (10 in North American models). Not used in
U.K. or International models.