Manitowoc Ice QM20 - Manual (Page 12)

Installation Instructions Section 2
2-4
ELECTRICAL CORD STRAIN RELIEF
To prevent strain at the electrical connection inside
the ice machine, an electrical cord strain relief device
must be installed on the rear panel of the ice machine.
1. Disassemble the strain relief device into its three
components.
2. Install the cord holder through the opening in the
lower right corner of the rear panel of the ice
machine.
Strain Relief Installation
3. Hand-tighten the retaining nut onto the cord
holder from inside the ice machine rear panel.
4. Slide the compression nut over the electrical cord.
5. Feed about 1.5 m (5 ft.) of electrical cord through
the cord holder. (The extra cord will allow the
rear panel to be removed for future service.)
6. Hand-tighten the compression nut onto the cord
holder.
TERMINAL BLOCK WIRE CONNECTION
WARNING
Always disconnect power to the ice machine before
working on electrical circuitry.
After the electrical cord is installed in the strain relief
device, the cord must be connected to the terminal
block to supply power to the ice machine.
1. Remove two Phillips head screws to remove the
lower panel from the front of the ice machine.
2. Carefully reach into the ice machine and pull the
electrical cord forward to the terminal block.
3. Strip away enough insulation from the electrical
cord to allow for good electrical connections at
the terminal block .
Terminal Block Connections
4. Open the screw terminals on the terminal block.
5. Connect each wire in the electrical cord to the
appropriate screw terminal.
6. Carefully tighten the screws over the wire.
7. Tug lightly on each wire to be sure the
connections are secure.
SV1706
ELECTRICAL
CORD
SV1707
COMPRESSION
NUT
CORD
HOLDER
RETAINING NUT
(BEHIND THE PANEL)
ELECTRICAL
CORD
TERMINAL
BLOCK
L1
N
GND