Muratec F-300 - Manual (Page 115)

7-3 C
OPYING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
C
OPYING
Making copies
Making copies using the ADF
1
Switch the machine to copy mode by pressing [COPY

FAX

SCAN].
Copy Ready 01
Auto Ltr 100%
2
Place your document face up on the ADF and adjust the document guides to the docu-
ment size.
3
As needed, set the copy settings including the document type and scanning contrast,
number of copies, zoom ratio and sort setting. See “Basic copy settings” on page 7-4.
To clear the settings, press [Reset].
4
Press [Start] to begin copying.
To stop copying, press [Stop].
Making copies using the document glass
The document glass is available only for the MFX-1330.
1
Switch the machine to copy mode by pressing [COPY

FAX

SCAN].
Copy Ready 01
Auto Ltr 100%
2
Make sure that there is no document on the ADF. If a document is on the ADF, it
takes priority over the document on the document glass.
3
Place your document face down on the document glass and align it to the upper left
corner. Then close the platen cover.
4
Press [Doc. Size] to select the document size, Letter, Half-letter or Legal.
5
As needed, set the copy settings including the document type and scanning contrast,
number of copies, zoom ratio and sort setting. See “Basic copy settings” on page 7-4.
To clear the settings, press [Reset].
6
Press [Start] to begin copying.
To stop copying, press [Stop].