Makita 2702X1 User Manual

Page 15

Place the stays on a level location and assemble the legs
inside. Secure with the bolts and nuts, then attach the
rubber caps to the ends of the legs.

Now set the table saw on top of the assembled stand and
secure with four bolts, washers and nuts.

NOTE:

•

Models 2702X1 and 2703X1 are standard-
equipped with a table saw stand.

•

Steel & Carbide-tipped saw blades

•

Sub table set (Left / Right)

•

Rip fence

•

Miter gauge

•

Offset wrench 13-22

•

Wrench 19

•

Key (Switch button)

•

Holder cap opener

•

Joint ( for connecting to dust collector )

•

Stand set

EN0006-1

MAKITA LIMITED ONE YEAR WARRANTY

Warranty Policy

Every Makita tool is thoroughly inspected and tested
before leaving the factory. It is warranted to be free of
defects from workmanship and materials for the period of
ONE YEAR from the date of original purchase. Should
any trouble develop during this one year period, return
the COMPLETE tool, freight prepaid, to one of Makita’s
Factory or Authorized Service Centers. If inspection
shows the trouble is caused by defective workmanship or
material, Makita will repair (or at our option, replace)
without charge.

This Warranty does not apply where:

•

repairs have been made or attempted by others:

•

repairs are required because of normal wear and
tear:

•

the tool has been abused, misused or improperly
maintained:

•

alterations have been made to the tool.

IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY
INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAM-
AGES FROM THE SALE OR USE OF THE PRODUCT.
THIS DISCLAIMER APPLIES BOTH DURING AND
AFTER THE TERM OF THIS WARRANTY.

MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED
WARRANTIES, INCLUDING IMPLIED WARRANTIES
OF “MERCHANTABILITY” AND “FITNESS FOR A SPE-
CIFIC PURPOSE,” AFTER THE ONE YEAR TERM OF
THIS WARRANTY.

This Warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limi-
tation or exclusion may not apply to you. Some states do
not allow limitation on how long an implied warranty lasts,
so the above limitation may not apply to you.

1. Rubber cap
2. Nut
3. Leg
4. Under stay
5. stay

1. Bolt
2. Stand

006877

006878

Table/Miter saw
blades

For general purpose cuts for table and miter saws.

Combination

General purpose blade for fast and smooth rip,
crosscuts and miters.

Fine cross cuts

For sand-free cuts cleanly against the grain.

006586