Makita 2702X1 User Manual

Page 13

CAUTION:

•

For a 1/8” cut width, the outside cutter is assembled
to the spindle in the same manner as the saw
blade.

•

The outer flange or the dado outer flange must be
used for each cut width.

•

The hex nut alone must not be used to secure the
dado on to the spindle.

NOTE:

•

When widths slightly greater than the above are
required, fit the paper washers in between the
inside and outside cutters to adjust the width.

Arrange the cutters so that the tips of the inside cut-
ters are positioned at the gullets of the outside cut-
ter. When more than one inside cutter is used,
space the tips of the inside cutters equidistantly in
relation to one another. Poorly spaced cutters may
cause vibration and noise.

When installing two outside cutters without any inside
cutter, be sure that the cutter tips do not face each other.

While tightening the hex nut, be careful to maintain
the even spacing between the tips of the inside cut-
ters.

Rotate the dado head one turn by hand to make
sure that it does not contact anything before opera-
tion.

CUT
WIDTH

1/4"

5/16"

3/8"

7/16"

1/2"

1/8"

Spindle

Inner
flange

Ring

Outside
Cutter

1/8"
Inside
cutter

1/16"
Inside
cutter

Outer
flange

Dado
Outer
flange

Outside
cutter

Washer

Hex
nut

Dado

Hex
nut

006893

1. Outside cutter
2. Inside cutter
3. Gullet

006178

006179