Makita 2702X1 - Manual (Page 12)

12
• Outside cutters: 6”diameter, 1/8” thick, 5/8”arbor
hole, 2 pcs.
• Inside cutters: 6”diameter, 1/8”thick, 5/8”arbor hole,
2 pcs.
• Inside cutter: 6”diameter, 1/16”thick, 5/8”arbor hole,
1 pc.
• Paper washers: 5/8”arbor hole, 6 pcs.
Various combinations of these cutters are used to cut
grooves from 1/8” to 1/2” for use in making joints, tenon-
ing, grooving, etc.
Dado flange set (Part No. 192693-8)
1. Dado outer flange
When cutting groove 1/4”, 5/16”, 3/8”, 7/16” or 1/2”,
use this dado outer flange.
2. Dado hex nut
When cutting groove 1/4”, 5/16”, 3/8”, 7/16” or 1/2”,
use this dado hex nut.
3. Ring
When cutting groove 1/4”, 5/16”, 3/8”, 7/16” or 1/2”,
use this ring.
4. Washer
When cutting groove 1/4”, 5/16” or 3/8”, use this
washer.
Table insert (Part No. 317061-6)
When cutting grooves 5/16”, 3/8”,7/16” or 1/2” use this
table insert instead of the standard table insert.
To install the dado head set, proceed as follows:
1. Turn the tool off and unplug it before installing.
2. Remove the blade guard with the spreader.
3. Install the dado head set with the teeth pointing
down at the front of the table.
4. Use the chart below to select the proper cutters to
obtain the various cutting widths.
1
2
3
4
006891
006892