McCulloch 96041016500 User Manual

Page 23

BAGGER PARTS
TEILE DES GRAS-AUFFANGBEHÄLTERS
PIÈCES DE RECHANGE DU RAMASSE-HERBE

TO ASSEMBLY BAGGER

PIEZAS DE LA ENSACADORA
PARTI DEL SACCO DI TELA
ONDERDELEN OPVANGBAK

1/4 x 20 x 1.25”

Carriage Bolts

Karosserieschrauben

Boulons de carrosserie

Tornillos de cabeza redonda

Bulloni a testa tonda

Slotbouten

1/4 x 20 x 1.15

Shoulder Bolts

Ansatzschrauben

Boulons à épaulement

Pernos de tope

Bulloni di spallamento

Borstbouten

1/4 x 20

Flange Lock Nuts

Flanschkontermuttern

Écrous frein

Tuerca de presión con brida

Dadi flangiati

Flensborgmoeren

Clevis Pin

Gabelstift

Axe de chape

Pasador de horquilla

Perno

Vorkbout

Retainer Spring Clip

Federklammer-Sicherung

Attache à ressort

Abrazadera de

arandela de retención

Clip di fissaggio

Sluitveerklem

• Remove clevis pin (7) and retainer spring (8) from bagger

handle (9).

• Slide bagger handle (9) down through bagger cover and

frame upper weldment holes.

• Reinstall clevis pin (10) through hole at bottom of bagger

handle and slide retainer spring (11) into hole at the end of

the clevis pin until it locks into place

• Uninstall (1/4”-20) lock nuts (4) at bottom of front bagger frame.
• Unfold cross braces (5) and attach to carriage bolts (6) at

bottom corners of front bagger frame.

• Reinstall (1/4”-20) lock nuts (4) and tighten until fully seated.

• Unfold bag and stand right side up.
• Feed front bagger frame (1) up through fabric loops at each

side of bagger.

• Snap bottom of front bagger frame (1) into snap feature at

front of bagger bottom.

• Slide bagger fabric loop (2) segments at the ends of bag

onto top bagger frame tubing.

• Uninstall two (1\4”-20 x 1.15”) hex bolts (3) from the front of

top frame.

• Reinstall the two (1\4”-20 x 1.15”) hex bolts (3) through holes

at top of the front bagger frame and thread into nuts inside

the tubing of top bagger frame.

TO ADJUST BAGGER FULL LEVER/PADDLE

• Before adjusting, tractor engine must be shut off and parking

brake engaged.

• For the heaviest/wet grasses, remove paddle (3).
• For lighter grasses use the paddle (3) on setting “1”, “2”, or

“3” (“3” being for the lightest or dry grass).

• Choose your setting and rotate the bagger paddle (3) so that

the desired number (setting) faces you.

• Setting may be changed by loosening fasteners (4 and 5),

removing/rotating paddle (3), and tightening again.