Moffat TURBOFAN E20M - Manual (Page 10)

Cleaning
8
Lamp Glass (Not E22M3)
a. With side racks and fan baffle removed, unscrew
lamp glass, anti-clockwise.
b. Clean the lamp glass using a soft cloth with a mild
anti bacterial detergent and a hot water solution.
c. Dry the lamp glass thoroughly with a dry cloth.
d. To refit the lamp glass, screw the glass in clockwise.
Do not over tighten the lamp glass.
Door Seal
a. To remove door seal, pull the 1 piece seal forward
until it pulls out of the location groove around the
oven. Note the way the seal is fitted to the
oven, with the lip facing inwards.
b. Check for wear and damage to the door seal and
replace as required.
c. Wash the door seal in a sink, taking care not to cut
or damage the seal.
d. Dry the door seal thoroughly.
e. Refit door seal with lip facing into centre of the
oven.
f. Press the door seal into the locating groove in the
front face of the oven until the seal is properly
located all around the oven.
Oven Interior
• Allow the oven interior to cool to approx 50˚C /
120˚F before commencing cleaning.
a. Remove the oven racks and the fan baffle as shown
previously.
b. Clean any build up of grease from the oven interior,
using a mild anti bacterial detergent, a hot water
solution and a soft bristled brush.
c. Dry the oven thoroughly with a soft dry cloth.
d. Clean the oven regularly with a good quality oven
cleaner.
Door Glass Cleaning
•
Ensure that the oven door is cool before cleaning
the door glass.
a. Open the oven door.
NOTE: Maintain a hold of the door with one hand
whilst cleaning the inner glass, to prevent the
door from closing.
b. Whilst holding the oven door in the open position,
grasp the bottom of the inner glass and pull glass
towards you until the top of the inner glass rises up.
c. Grasp the inner glass by the finger tabs at the top
of the glass and raise the inner glass to the vertical
position.
Unscrew Anti-
Clockwise
Refit Seal with Lip
facing inwards
Pull Seal out of
locating channel
Finger Tabs