Memorex MPD8857 - Manual (Page 7)

6
RADIO OPERATION
Set the VOLUME control ❶ to minimum
and plug the headphone into the
PHONES jack. Press the PLAY/PAUSE
(
) /POWER ON button ❷ to turn the
unit on.
1
2
1
TO LISTEN TO THE RADIO
Slide the FUNCTION switch ❶ to the RADIO
position. Press the MENU/ESP/BAND
button ❷ to select a band (AM or FM). If
listening to FM, press the MODE/¥ button
❸
to select Stereo or Mono.
1
2
3
2
Press and release the Skip/TUNING DN
❶ or UP ❷ button to tune a
station. Press and hold the
Skip/TUNING DN
❶ or UP ❷
button for Auto Scan tuning (see below).
2
1
3
Adjust the VOLUME control ❶ and DBBS
switch ❷ as desired. If FM STEREO
reception is weak/noisy, press the
MODE/¥ button ❸ to Mono, in this case
the reception will be monaural.
1
2
3
4
To turn the radio off, press the STOP
(■)/POWER OFF button.
5 ANTENNAS
AM – This unit has a built-in ferrite bar
antenna, which provides adequate reception
in most areas. If reception is weak, turn the
unit to improve reception.
FM – The headphones act as an antenna for
FM. Extend the headphone wire for best FM
reception.
AUTO SCAN
Press and hold the Skip/TUNING DN
or
UP button for approximately one second
and the unit will automatically search for the
next available station.
MPD8857.O/M.QXD 5/2/03 9:12 AM Page 6