Metrologic Instruments Laser Scanner - Manual (Page 44)

40
MS7220 S TANDS
Vertical Stand Installation [ MLPN 46-46405 ]
Remove the three screws
securing the cable cover to the
unit and slide it up and off the
scanner. Disconnect the cable
and slide the horizontal stand
up and off the unit. Disassemble the horizontal stand and
remove the horizontal cover plate.
Mounting the MS7220: Peel off the base plate’s tape backing and affix it to the
countertop or drill four #39 pilot holes and secure the base plate to the countertop
with the four #8 wood screws provided.
Replace the horizontal base
cover with the vertical base cover
[ 36-00363 ] then reassemble. Move the side cover from the vertical
to the horizontal position on the unit.
Slide the vertical stand onto the
unit. Reattach the cable and secure the cable
cover with the three M3 screws.