Metrologic Instruments Laser Scanner - Manual (Page 16)

12
I NSTALLATION OF AN A UXILIARY S CANNER
11. Configure the auxiliary scanner to send formatted
data to the MS7220. Normal slave mode operation
will only require reserve Code 32 to be set in the
auxiliary scanner. The Reserve Code 32 bar code
applies for all scanners, except the MS6720, to be
used as an auxiliary scanner. Contact a Metrologic
representative for information on the MS6720.
12. Configure the MS7220 to activate the auxiliary port. Enable the auxiliary
port and configure it to recognize slave formatted data with the following bar
code:
³ 4 3 7 3 3 0
Enable Aux Port
13. Turn on the host system.
Figure 6: Auxiliary Scanner Setup
³ 1 2 4 8 1 7
Reserve Code 32