Motorola T7200 - Manual (Page 28)

23
Changing your Radio
’s Settings
\
Changing your Radio’s Settings
Setting the Channel
•
Turn radio On.
• Press [ or ] to select Channel.
Note: The red indicator light below the antenna on the left front of
the radio flashes every second when the Channel is in use.
To set Repeater Channels (T7200 only), please refer to Setting Repeater
Channels on page 35.
Setting the Interference Eliminator Code
The Interference Eliminator Code helps minimize interference by
providing you with a choice of code combinations.
•
Turn radio On.
• To set, press \ once the Code display begins to flash.
• Then press [ or ] to choose the Code.
• Press M to exit this menu.
Note: To hear everyone on your Channel, select Interference Eliminator Code 0.
You can specify a different Interference Eliminator Code for each Channel.
•
To set a Channel and Code combination, press
[
or
]
to select the Channel.
• Press
\
and then press
[
or
]
to select a Code.
• To exit the menu, press M.
• To set another Channel and Code combination, repeat these steps.
Note: To set your Repeater Interference Eliminator Code (T7200 only), please refer
to Setting Repeater Interference Eliminator Codes on page 35.
6
6864110R94.book Page 23 Friday, February 8, 2002 2:34 PM