Motorola M6800 - Manual (Page 9)

MPU-9
Counter, Accumulators, and Condition Code Register are
stored away on the stack. Next the MPU will respond to the
interrupt request by setting the interrupt mask bit high so
that no further interrupts may occur. At the end of the
cycle, a 16-bit address will be loaded that points to a
vectoring address which is located in memory locations n-6
and n-7 where n is the highest ROM address. An address
loaded at these locations causes the MPU to branch to an
interrupt routine in memory.
5. Phase One (Øl)& Phase (Ø2)Clocks:
These two pins are used or a two phase non-overlapping
clock that runs at the V DD voltage level.
These clocks run at a rate up to 1 megahertz.
6. Restart (RES):
RESTART (RES)--This input is used to start the MPU from a
power down condition, resulting from a power failure or an
initial start-up of the processor. If a positive edge is
detected on the input, this will signal the MPU to begin
the restart sequence. This will restart the MPU and start
execution of a routine to initialize the processor. All the
higher order address lines will be forced high. For the
restart, the last 2 memory locations in the last ROM
(n&n-1) will be accessed, whereby an address is stored
which is the address to be loaded in the program counter
which tells the processor where program execution is to
begin.
7. NON-MASKABLE INTERRUPT(NMI):
This input requests that a nonmask-interrupt sequence be
generated within the processor. As with the Interrupt