MITSUBISHI ELECTRIC 737 - Manual (Page 39)

4. TV Menus 39
Initial, continued
Energy Lamp
Energy Standard,
Bright Standard is for most viewing conditions. Use Bright in brightly lit rooms.
You may notice increased fan noise when using the
Bright setting.
Channel
(Channel
Manage-
ment)
Ant Air,
Ant Cable You must perform a channel scan to receive digital channels. Scan searches for broad-
cast channels and adds them to TV memory. To start channel scan:
Highlight one of the input selections based on your connection to the 1. ANT input:
Air • when connected to an indoor or outdoor antenna.
Cable • when connected to direct cable (no cable box)
Press 2. to highlight SCAN.
Press 3. ENTER to start channel memorization.
Scan
Edit After channel scan, Edit lets you add and delete memorized channels.
• Press PAGE DN/UP to jump to the next or previous page of channel numbers.
• Press to move through all channel numbers, one at a time.
Notes on Scan and channel memorization
• Channel memorization may take up to 15 minutes
to complete.
• To stop channel memorization before completion,
press CANCEL. Channels already added are retained.
• When watching TV, press CH to move through
memorized channels.
• To add a digital channel that does not appear in the
Edit menu without repeating channel memorization:
Look up the 1. physical channel number for
the new digital channel. See the website
www.antennaweb.org for help.
Press 2. ACTIVITY and select the ANT input.
Use the number keys and 3. CANCEL key to enter
the physical channel number followed by “-1”
and
ENTER. For example, for physical channel
36, press
3 6 1 ENTER.
The TV will search for a digital channel on the channel
36 frequency. When it finds the channel, it will:
a. Add the channel to memory.
b. Change the channel number to the virtual
channel number sent by the broadcaster.
c. Add to memory any associated sub-
channels.
Rememorize channels if you move the TV to a differ- •
ent geographic area with a different channel line-up.
Adding/Deleting Channels Using the Channel Edit Menu
Channels marked with a check are in memory. •
To add or delete a channel from • memory, highlight the channel number and press ENTER.
To add a single digital channel not in the list, see the notes under • Scan on this page.
Digital channels are listed by virtual channel number with the physical channel number shown in small gray text. •
See below for an explanation of these terms.
Virtual - Channel Number (digital channels only). A channel number sent by a local broadcaster. Usually the
virtual number is associated with the corresponding analog channel number. For example, a broadcaster may
associate digital channel 2-1 with their analog channel 2.
Physical Digital Channel Number.
- The channel number officially assigned to the actual broadcast frequency;
shown on screen in gray text.