Milan Technology MIL-S8001TG - Manual (Page 30)

26
4-3. QoS Control
Select QoS Control to access the QoS configuration menu. The system
supports two methods of QoS control – Port-Based and 802.1P/TOS.
From the Main Menu, enter "q" or "Q" to select QoS Control to enable or
disable the Qos function and set the high/low queue priority ratio.
Port-Based Enable: Enter “p” or “P” at the command prompt to enable
Port-Based function.
802.1P/TOS Enable: Enter “e” or “E” at the command prompt to enable
802.1P/TOS function.
Note: Port-Based or 802.1P/TOS function must be anabled prior to
configuring the Priority ID Map function.
QoS Disable: To disable QoS control, enter “d” or “D” at the command
prompt.