Milan Technology MIL-S8001TG - Manual (Page 25)

21
4-2-1-3. Create VLAN Group
Enter “c” or “C” at the command prompt to access the Create VLAN Group
configuration interface.
VLAN group ID: Enter the VLAN Group ID at the prompt.
Add VLAN group member: Enter “m” or “M” at the command prompt to add
the port to the VLAN group, use the command “+port number” to add the port
or enter “+A” to add all ports. To remove the port from VLAN group, use the
command “-port number” or enter “-A” to remove all ports from group. A
maximum of 8 ports can be added to a VLAN group. After the port(s) are
added the VLAN group, enter command “q” or “Q” to exit the configuration
interface.