McIntosh MDLP2 User Manual
Page 29
29
How to Operate the MDLP2, con’t
Wireless: Selects external sensor(s) only.
Wired: Selects the two internal sensors
and any external sensor(s) connected to
the MDLP2.
Note: When making a change to the cur-
rent menu setting, the ENTER Push-
button on the MDLP2 Control Panel
must be used to effect the desired
change.
Reset Lamp Life - The projection lamp used in the MDLP2
has a maximun life expectancy of 2,000
hours.
If at any time you would like to know
how many hours of use are left for the
lamp, press the INFO Push-button on
the Remote Control and the On-Screen
Display will appear indicating the num-
ber of hours remaining. Refer to figure
35.
When there is aproximately 100 hours
of lamp life remaining, an On-Screen
Warning Message will appear briefly.
Refer to figure 36.
If you have chosen not to replace the
lamp at this time, a second warning
message will appear with approximately
5 hours remaining. Refer to figure 37.
Finally, the last warning message will
appear On-Screen, the MDLP2 Projec-
tor will shut Off and the Control Panel
WARNING/LAMP LED will illumi-
nate red. Refer to figure 38.
After your McIntosh Dealer has re-
placed the Projector Lamp, check to
make sure the Lamp Life has been reset
by pressing the INFO Push-button on
the Remote Control. The On-Screen
Display should indicate 2,000 hours. If
it was not reset, please do so it at this
time by selecting the Reset Lamp Life
from the On-Screen Menu. Then select
YES and press the ENTER Push-but-
ton. Refer to figure 39.
Reset All - If it becomes necessary to reset all the menu
settings back to factory defaults (except for the
Lamp Life Setting), select the Reset All from
the On-Screen Menu and then select YES and
press the ENTER Push-button.
Refer to figure 40.
Reset of Microprocessors
In the unlikely event the controls of the MDLP2 stop
functioning, the microprocessors can be reset by discon-
necting the AC Power Cord from the MDLP2, waiting for
5 minutes and then reconnecting the AC Power Cord.
Reset All ?
Yes
No
Figure 40
Yes
No
Reset Lamp Life ?
Figure 39
Lamp Life 5 Hours
Warning
Figure 37
Lamp Life 0 Hours
Warning
Figure 38
Warning
Lamp Life 100 Hours
Figure 36
Figure 35
Information
Video Input
HDMI 1 - 1080p
Picture Mode
User 1
Gamma
A
Aspect
Normal
Lamp Mode
Economy
Iris
3
Lamp Life
921 Hours
Total Time
3653 Hours