Quick start – MITSUBISHI ELECTRIC N0701 User Manual
Page 10
E-2
Quick Start
To attach the Monitor to your system, follow
these instruction:
1 Turn off the power to your computer and the monitor.
2 If necessary, install the display card. For more information, refer to the
display card manual.
3 For the PC: Connect the 15-pin mini D-SUB of the captive signal
cable to the connector of the display card in your system (Figure A.1)
Tighten all screws.
For the Mac:
Connect the Macintosh Cable Adapter (not included)
to the monitor connector on the Macintosh (Figure B.1). Attach the 15-
pin mini D-SUB end of the captive signal cable to the Macintosh cable
adapter on the computer (Figure B.1). Tighten all screws.
4 Connect one end of the power cord to the monitor and the other end to
the power outlet (Figure C.1).
5 Turn on the monitor (Figure D.1) and the computer.
6 This completes the installation.
NOTE:
If you have any problems, please refer to the
Troubleshooting
section of this User's Manual.
Captive Signal Cable
15-pin-mini-D-SUB
Figure A.1