Metrologic Instruments Genesis MS7580 - Manual (Page 9)

5
I
NTRODUCTION
Cable Installation and Removal
Installation
Important: If the cable is not fully ‘latched’ the unit may
power intermittently.
Figure 2.
1. Insert the 10-pin RJ45 end of the cable into the socket on the MS7580.
There will be an audible click when the connector lock engages.
2. Gently pull on the cable strain relief to insure the cable is installed.
Removal
Before removing the cable from the unit, Metrologic recommends that the power
on the host system is off and the power supply has been disconnected from the
cable.
Figure 3. Releasing the Cable
1. Locate the small ‘pin-hole’ on the unit near the cable.
2. Bend an ordinary paperclip into the shape shown above.
3. Insert the paperclip (or other small metallic pin) into the small ‘pin-hole’.
4. There will be a faint ‘click’ when the lock is released. Pull gently on the
strain-relief of the cable to remove the cable from the unit.