Metrologic Instruments Genesis MS7580 - Manual (Page 17)

13
W
ALL
M
OUNT
PN 46-00911, Installation
1. Remove the rubber feet on the bottom of the MS7580.
2. Attach the base adapter plate to the bottom of the unit with the
four M3 x .5 x 10 mm screws ( ˆ ).
3. Attach the base plate to the base plate adapter with the four
M3 x .5 x 8 mm ( ~ ).
Figure 11
4. Before mounting the locking plate, consider the position the unit will rest
when fully installed. There are two tabs located on the locking plate.
These tabs indicate the two directions the unit may face when locked into
position.
Figure 12