Multi-Tech Systems MT2834BLR - Manual (Page 39)

39
Chapter 4 - Commands
VALUES: n = 0, 1 or 2
DEFAULT: Q0
DESCRIPTION: Q0 selects Result Codes displayed.
Q1 selects Result Codes suppressed (quiet).
Q2 selects Dumb Answer Mode.
COMMAND: &Qn
VALUES: n = 0 or 1
DEFAULT: &Q0
DESCRIPTION: &Q0 selects Multi-Tech command set.
&Q1 selects AT command set.
COMMAND: Rn
VALUES: n = 0 or 1
DEFAULT: R0
DESCRIPTION: R0 means modem will not reverse modes.
R1 means modem will reverse modes.
COMMAND: &Rn
VALUES: n = 0, 1 or 2
DEFAULT: &R1
DESCRIPTION: &R0 lets Clear to Send act normally.
&R1 forces Clear to Send on.
&R2 drops for 1 second on disconnect.
COMMAND: $Rn
VALUES: n = 0 or 1
DEFAULT: $R0
DESCRIPTION: $R0 selects disconnect after 12 retransmits.
$R1 selects do not disconnect after 12 retransmits.
COMMAND: &RFn
VALUES: n = 0 or 1
DEFAULT: &RF1
DESCRIPTION: &RF0 selects CTS follows RTS.
&RF1 selects CTS to act independently
COMMAND: Sr=n
VALUES: r = 0-11, 13, 15-17, 24-26, 29, 30, 32, 34, 36, 37, 48
DEFAULT: n/a
DESCRIPTION: Sets value of S-Register “r” to value of “n”, where “n” is
entered in decimal format.
COMMAND: Sr?