Chapter 4 - commands – Multi-Tech Systems MT2834BLR User Manual
Page 37
37
Chapter 4 - Commands
VALUES:
n = 1 thru 3
DEFAULT:
Read Only Command
DESCRIPTION:
$H1 brings up Help Screen #1.
$H2 brings up Help Screen #2.
$H3 brings up Help Screen #3.
COMMAND:
In
VALUES:
n = 0,1or 2
DEFAULT:
Read Only Command
DESCRIPTION
I0 requests modem ID #.
I1 requests firmware revision #.
I2 for MTS internal use.
COMMAND:
I9
VALUES:
N/A
DEFAULT:
Read Only Command
DESCRIPTION:
The I9 command is a query to display this modem's
characteristics when operating within Windows 95. Entering
ATI9
monitor.
(The response to the query reveals that your
modem is a BR, 28.8K, FAX and Class Two capable
device.)
COMMAND:
L
VALUES:
5, 6, 7, 8, 9, 10 and 11
DEFAULT:
Read Only Command
DESCRIPTION:
Lists all stored telephone numbers in memory.
L5 lists all current operating parameters.
L6 lists all current S-Register values.
L7 lists additional parameters.
L8 lists current on-line diagnostics.
L9 displays Signal Strength Information.
L10 displays Signal to Noise Ratio Information.
L11 displays Noise Information.
COMMAND:
#Ln
VALUES:
n = 0 thru 3
DEFAULT:
#L0
DESCRIPTION:
#L0 selects modems negotiate V.42 Mode.
#L1 selects MNP on and LAP-M off.
#L2 selects LAP-M on and MNP off.
#L3 selects no detection phase; go directly to LAP-M
mode.
COMMAND:
$MBn