Makita 2703X1 - Manual (Page 6)

6
18. Do not perform any operation freehand.
Freehand means using your hands to sup-
port or guide the workpiece, in lieu of a rip
fence or miter gauge.
19. NEVER reach around or over saw
blade. NEVER reach for a workpiece until
the saw blade has completely stopped.
20. Avoid abrupt, fast feeding. Feed as
slowly as possible when cutting hard work-
pieces. Do not bend or twist workpiece while
feeding. If you stall or jam the blade in the
workpiece, turn the tool off immediately.
Unplug the tool. Then clear the jam.
21. NEVER remove cut-off pieces near the
blade or touch the blade guard while the
blade is running.
22. Knock out any loose knots from work-
piece BEFORE beginning to cut.
23. Don’t abuse cord. Never yank cord to
disconnect from receptacle. Keep cord
away from heat, oil, water and sharp
edges.
24. Some material contains chemicals
which may be toxic. Take caution to pre-
vent working dust inhalation and skin con-
tact. Follow material supplier safety data.
25. The guard can be lifted during work-
piece setup and for ease of cleaning.
Always make sure that guard hood is
down and flat against sawtable before
plugging in the tool.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in this instruction manual may cause
serious personal injury.