Makita 2703X1 - Manual (Page 23)

23
How to perform rabbeting
1. Remove blade guard.
2. Attach auxiliary fence to rip fence for cuts that run the
length of the stock. Facing should be as high as the
workpiece is wide. Adjust fence and blade to desired
dimensions.
3. First cut: Hold board flat on table as in ordinary rip-
ping.
4. Second cut: Set workpiece on its edge. (Use feather-
boards, push stick, push block and so on, using pre-
cautions, safety rules and guidelines for ripping or
related work.)
5. For end-type rabbeting, if the workpiece is less than
10-1/2” wide, rest the wood flat on the table against
the miter gauge (with wood facing). The rip fence
should not be used.
6. After rabbeting is completed, immediately re-install
the blade guard as before.
Table saw stand (Part No. 192680-7)
Place the stays on a level location and assemble the
legs inside. Secure with the bolts and nuts, then attach
the rubber caps to the ends of the legs.
Now set the table saw on top of the assembled stand
and secure with four bolts, washers and nuts.
NOTE:
• Models 2702X1 and 2703X1 are standard-equipped
with a table saw stand.
1. Rabbet
2. First cut
3. Second cut
1
2
3
1. Bolt
2. Stand
1
2
1
3
5
4
2
1. Rubber cap
2. Nut
3. Leg
4. Under stay
5. Stay