Makita 2703X1 - Manual (Page 13)

When operating the switch lever, it is convenient to
view it through the window area in the table.
CAUTION:
• When not using the tool, remove the key and store it
in a secure place. This prevents unauthorized opera-
tion.
• Before plugging in the tool, always check to see that
the switch lever actuates properly and returns to the
“OFF” position.
• Do not pull the switch lever hard without the key. This
can cause breakage of the switch.
CAUTION:
• Always use “work helpers” such as push sticks and
push blocks when there is a danger that your hands or
fingers will come close to the blade.
• Always hold the workpiece firmly with the table and
the rip fence or miter gauge. Do not bend or twist it
while feeding. If the workpiece is bent or twisted, dan-
gerous kickbacks may occur.
• NEVER withdraw the workpiece while the blade is run-
ning. If you must withdraw the workpiece before com-
pleting a cut, first switch the tool off while holding the
workpiece firmly. Wait until the blade has come to a
complete stop before withdrawing the workpiece.
Failure to do so may cause dangerous kickbacks.
• NEVER remove cut-off material while the blade is run-
ning.
• NEVER place your hands or fingers in the path of the
saw blade. Be especially careful with bevel cuts.
• Always secure the rip fence firmly, or dangerous kick-
backs may occur.
• Always use “work helpers” such as push sticks and
push blocks when cutting small or narrow workpieces,
or when the dado head is hidden from view while cut-
ting.
Work helpers
Push sticks, push blocks or auxiliary fence are types of
“work helpers”. Use them to make safe, sure cuts with-
out the need for the operator to contact the blade with
any part of the body.
13
OPERATION