Makita 2703X1 - Manual (Page 20)

Table insert
(Part No. 317061-6)
When cutting grooves 5/16”, 3/8”,7/16” or 1/2” use this
table insert instead of the standard table insert.
To install the dado head set, proceed as follows:
1. Turn the tool off and unplug it before installing.
2. Remove the blade guard with the spreader.
3. Install the dado head set with the teeth pointing down
at the front of the table.
4. Use the chart below to select the proper cutters to
obtain the various cutting widths.
CAUTION:
• For a 1/8” cut width, the outside cutter is assembled to
the spindle in the same manner as the saw blade.
• The outer flange or the dado outer flange must be
used for each cut width.
• The hex nut alone must not be used to secure the
dado on to the spindle.
20
CUT
WIDTH
1/4"
5/16"
3/8"
7/16"
1/2"
1/8"
Spindle
Inner
flange
Ring
Outside
Cutter
1/8"
Inside
cutter 1/16"
Inside
cutter
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
x 2
•
Outer
flange
Dado
Outer
flange
Outside
cutter
Washer
Hex
nut
Dado
Hex
nut
•
•
•
•
•
•
•
•
•
•
•
•
•
• •
•
•
•
•
•