Meade Instruments LT SC Series - Manual (Page 37)

To Add a landmark to the database:
In this procedure, you will store the location of terrestrial
landmarks in AutoStar’s memory.
1. Set the telescope in the home position, if
necessary. Note for future reference where the
telescope is located and if you have aligned the
telescope, which alignment method is used.
IMPORTANT NOTE: To use the Landmark
function, the telescope must be located and
aligned exactly as when the landmark(s) was
added to the database.
2. Display the “Setup: Targets” menu option.
Choose “Terrestrial” and press ENTER – “Setup:
Targets” displays again. Choosing this option
turns off tracking for astronomical objects and
is not useful for the viewing of terrestrial objects
such as those in the Landmark database. Be
sure to change this option back to “Astronomical”
when you wish to view celestial objects again.
3. Press MODE once. “Select Item: Setup”
displays.
4. Press the Scroll Down key once and “Select
Item: Object” displays. Press Enter. “Object:
Solar System” displays.
5. Press the Scroll Up key twice and “Object:
Landmarks” displays. Press ENTER.
“Landmark: Select” displays.
6. Press the Scroll Down key once. “Landmark:
Add” displays. Press ENTER.
7. “Landmark Name” displays. Using Arrow
keys, enter a name for the landmark you
wish to add to the database. When fi nished,
press ENTER.
8. “Center Landmark. Press Enter” displays.
Using only the Arrow keys (do not manually
move the telescope), move the telescope to
the desired landmark and center the object in
the eyepiece. Press Enter. The object is now
stored in memory.
9. “Landmark: Add” displays. If you wish to add
more landmarks, repeat steps 5 through 7.
To Select a landmark from the database:
1. Make sure the telescope is located and aligned
exactly as when the desired landmark was
entered into memory.
2. Display the “Landmark: Select” menu option.
Press ENTER.
3. Use the Scroll keys to scroll through the list
of objects you have previously entered. When
the desired object displays, press ENTER to
select the object. Use the Scroll keys to scroll
through location information about the object, if
desired. Press GO TO to slew the telescope to
the landmark.
4. Press MODE to exit.
To perform a Landmark Survey
This procedure allows you to perform a tour of the
objects entered in the “Object: Landmark” menu
option – note that the Landmark Survey will function
only if you have previously entered objects in the
Landmark menu.
1. Navigate to “Utilities: Landmark Survey” menu
and press ENTER.
2. “Landmark Survey: Slewing...” displays. The
telescope moves to the fi rst object on the Survey
list and displays the name of the object.
3. Press MODE to pause the Survey. Press
Enter to restart the survey at the fi rst object of
the survey.
To check on the available amount of memory in
AutoStar.
AutoStar has a limited amount of memory. Once you
begin to store Landmarks, User Objects and other bits
of information in AutoStar, you will begin to use up
memory. This procedure allows you to check on how
much memory is still available.
1. Navigate to the “Setup: Statistics” menu option
and press ENTER.
2. “Statistics: 97.4K Char. Free” displays. This is
the amount of memory that is still available to
the user.
INDEX
ADV
ANCED FEA
TURES
37