Middleby Marshall PS540 - Manual (Page 38)

34
SECTION 4
MAINTENANCE
4. Remove conveyor drive chain cover as shown.
5. Remove tension from drive chain by lifting and pushing
the conveyor slightly into the oven. Remove drive chain
from conveyor drive sprocket as shown.
NOTE: The split belt conveyor assembly can only be
removed from the drive end of the oven.
6. Begin sliding conveyor out of the oven as shown.
Figure 4-7.
7. Continue sliding the conveyor completely out of the
oven, fold it in half and then place it to the side for cleaning.
Be careful not to bump drive sprocket while handling
conveyor or damage may result to drive shaft.
Figure 4-8.
CAUTION
Be careful not to bump the drive sprocket while
handling the conveyor, to avoid damaging the
drive shaft.
Figure 4-4.
Figure 4-5.
Figure 4-6.