Philips Magnavox MRD300 - Manual (Page 25)

23
English
Tuning to radio stations
1 Press POWER ON•OFF to switch on the last selected
source.
2 Press TUNER•BAND (or press SOURCE on the
remote control repeatedly) to select TUNER mode.
3 Press TUNER•BAND again to select the desired band :
FM or AM.
4 Press and hold
S or T (or н / л on the remote
control) until the frequency indication starts to change, then
release.
➜ The system automatically tunes to the next strong radio
station.
STEREO
L R
S
● To tune to a weak station, press S or T (orн / л
on the remote control) briefly and repeatedly until an
optimal reception is found.
● To reduce the noise and make the radio reception clearer,
press ST/MONO to switch to monaural mode.
5 Repeat step 4 if necessary until you find the desired radio
station.
Presetting radio stations
You can preset up to 40 stations regardless of the
reception.
1 Tune to your desired radio station (refer to “Tuning to
radio stations
”.)
2 Press SLOW/MEM.
➜ “PROG” icon starts flashing.
STEREO
L R
S
PROG
3 Use the numeric keypad (0-9, >10) to select the
desired preset number.
➜ If “PROG” icon goes off before you select the desired
preset number, press SLOW/MEM again.
STEREO
L R
S
PROG
4 Press SLOW/MEM again or wait for a few seconds to
store the radio station.
● Repeat steps 1–4 to store other radio stations.
Helpful Hint:
– During programming, if no button is pressed within five
seconds, the system will exit the program mode automatically.
Listening to preset radio
stations
● In tuner mode, press а / б or use the numeric
keypad (0-9, >10) to select the desired preset number.
➜ The preset number, radio frequency, and waveband are
displayed.
Radio Reception
R
ADIO
R
ECEPTION