beautypg.com

Assembly instructions, Remove the cutting attachment, Remove the old cutting attachment shield – MTD BCR4 BCK User Manual

Page 8

background image

FIGURE 12

FIGURE 9

8

ASSEMBLY INSTRUCTIONS

FIGURE 11

REMOVE THE CUTTING ATTACHMENT

NOTE: To make removing or installing the cutting

blade or cutting attachment easier, place the
unit on the ground or on a work bench.

WARNING: The gear housing gets hot with
use and can result in injury to the operator.
When the unit is turned off it remains hot
for a short time. Do not touch the gear
housing until it has cooled.

1. Align the shaft bushing hole with the locking rod

slot and insert the locking rod into the shaft
bushing hole. See Figure 9.

Shaft Bushing Hole

Locking Rod

Slot

Output Shaft Bushing

Locking Rod

Output Shaft

2. Hold the locking rod in place by grasping it next to

the boom of the unit. See Figure 10.

3. While holding the locking rod, remove the cutting

attachment by turning it

clockwise off of the

output shaft. Store the cutting attachment for
future use. See Figure 11.

Cutting Attachment

Locking Rod

Slot

Locking Rod

REMOVE THE OLD CUTTING
ATTACHMENT SHIELD

WARNING: You MUST remove the cutting
attachment shield (on the existing unit) and
install the cutting attachment mount
(provided with the blade kit) when operating
the unit as a brushcutter.

Remove the cutting attachment shield from the gear
housing by the removing the three (3) bolts and nuts
with a 7/16 wrench. Keep the hardware to use while
installing the new cutting attachment shield mount.
See Figure 12.

Bolts

Cutting Attachment

Shield

Gear Housing

Nuts

FIGURE 10