MTD BCR4 BCK - Manual (Page 7)

FIGURE 8
FIGURE 7
FIGURE 6
FIGURE 5
FIGURE 4
7
ASSEMBLY INSTRUCTIONS
Adjustment
7. Loosen the screws so that the J-handle easily
moves in the clamp assembly. Do not remove the
screws or nuts.
8. Slide the J-handle in or out until the arrow/white
line on the decal touches the clamp assembly. See
Figure 4.
9. While holding the unit in the operating position,
arrange the J-handle in the location that provides
you with the best grip. See Figure 5.
10. Tighten the clamp screws evenly, until the
J-handle is secure.
Decal
Support Fitting
INSTALL THE HARNESS
WARNING: To avoid personal injury, always
use the shoulder harness when using the
cutting blade.
1. Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through
the slot in the buckle. See Figure 6.
3. Put the harness on over your head and onto your
shoulder. Snap it on to the support fitting. See
Figure 7.
4. Adjust length to fit the operator’s size. Pull tab to
lengthen, pull strap to shorten. See Figure 8.