Motorola WPCI810G - Manual (Page 43)

Troubleshooting Section 4
WPCI810 4-3
Software Solutions
How do I enable LEAP for my corporate network?
Ask your system administrator for the Domain/Username and Password required.
1 Right-click the antenna icon in the system tray and select Open Utility. The Motorola
Wireless Configuration Utility window displays.
2 Ensure that the Motorola Wireless Configuration utility is enabled; refer to Section 3 for
further details.
3 Add a new network; refer to Section 3 for details.
4 In the Preferred networks area, highlight the network you want to configure.
5 In the Available networks area click Configure, or in the Preferred networks area click
Properties.
6 Select the type of authentication required, in this case 802.1X. Match the authentication
used by the access point.
7 Select the type of encryption required, in this case CKIP. Match the encryption used by
the access point.
8 Click the Authentication tab to enter further details.
– Enter the Domain/Username and Password.
9 Click OK twice to save your changes.