M-AUDIO MicroTrack II - Manual (Page 20)

User Guide 19 MicroTrack II
Loop Playback
MicroTrack II will allow you to loop a section of an audio file This can be useful when practicing parts or studying
dictation The method for looping a file requires setting a start and end point, and is accomplished as follows:
1 To engage Loop Playback, press and hold the [MENU] button for over 2 seconds while the file is playing The
loop icon will appear on the lower left of the screen
2 Press the [MENU] button once when you reach the start point of the loop A small “+” will appear to the left of
the loop icon
3 Press the [MENU] button a second time when you reach the end point of your loop The section will begin to
loop immediately A small “+” will appear to the right of the loop icon
4 Pressing the [MENU] button a third time will exit loop mode
While using Loop Playback mode, you can:
<
Adjust the playback volume using the [VOLUME] button
<
Delete the file by pressing the [DEL] button
<
Immediately begin recording a new file by pressing the [REC] Button
<
Fast-forward through the file by holding the [NAV] wheel up
<
Skip ahead to the next file by pressing up on the [NAV] wheel
<
Return to the beginning of a file by pressing down on the [NAV] wheel
<
Rewind the file by holding down the [NAV] wheel
<
Pause playback by pressing in on the [NAV] wheel Press in again to resume playback
Additional [NAV] wheel functions when an audio file is paused in Loop Playback mode include:
<
Return to a previous file by pressing down on the [NAV] wheel
<
Resume playback by pressing in on the [NAV] wheel