Mark Levinson 433 - Manual (Page 14)

14
Mark Levinson
2. Power Button
Powers the Nº433 on and off when the power cord is connected to
the ~ac mains connector and an electrical outlet. When the Nº433
is powered on, pressing and releasing the power button disconnects
power from the ~ac mains connector and powers the Nº433 off.
When the Nº433 is powered off, pressing and releasing the power
button
connects power to the ~ac mains connector and powers the
Nº433 on. If the power save mode switch is set to on, the Nº433
enters sleep mode. If the power save mode switch is set to off, the
Nº433 enters standby. See page 18 for more information on the
power save mode switch.
Note: The Nº433 must be powered on with the power button to respond to
remote trigger commands.
3. Standby Button
Places the Nº433 into standby or sleep mode and takes the Nº433
out of standby or sleep mode. When the Nº433 is powered on,
pressing and releasing the standby button places the Nº433 into
standby
or takes the Nº433 out of standby, allowing it to remain
warmed-up to deliver optimal performance at all times.
Pressing and holding the standby button places the Nº433 into
sleep mode
. When the Nº433 is in sleep mode, pressing and
releasing the standby button takes the Nº433 out of sleep mode. If
the power save mode switch is set to on, the Nº433 powers on into
sleep mode
. If the power save mode switch is set to off, the Nº433
enters standby.