Mr. Coffee URTX87D - Manual (Page 9)

5.) For model UNT83: Open the resetvoir lid and fill
the resetvoir with cold water for the desired cup
level on the water window (up to 8 cups).
For models URT83, URTX83 and URTX87D:
Remove the water reservoir by grasping the hand
hokk in back of the reservoir, and pulling up.
All it with the desired amount of cold water. Replace
the reservoir on the coffeemaker, making sure that it
is firmly attached to the coffeemaker body.
Make sure the reservoir is squarely centered
on the coffeemaker or thc water may overflow.
An overflow may cause personal Injuy or
damage to property.
Do not remove thc water reservoir at any time
during the brewing cycle.
6.) Place the empty thermal carafe on the base.
To achieve the best performance rinse the thermal
with warm water. This will improve the heat
retaining capabilities of the thermal carafe. While
brewing, the Brew-Thru lid,must be on the thermal
carafe and the POUR arrow of the Iid must be
aligned with the spout. Otherwise,
the carafe
may overflow.
Make sure the thermal carafe Is squarely
centered on the base or the water and
grounds wlll overflow from the brew basket.
An overflow may cause personal Injury or
damage
to property.
To reduce the rlsk of damaging the thennal
carafe and/or the risk of personal injury, do
not add cold water to the thennal carafe If the
thermal carafe Is already hot. Allow the
thennal carafe to cool before using.
Brewing coffee now
For models UN783 snd URT83:
Press the ON button.
The ON indicator will illuminate, indicating that
the coffeemaker is on and the brew cycle will
begin. When the coffee stops flowing, the brew
cycle ls complete.
The coffeemaker will tum off automatically.
The indicator light will go out to let you know
the brew cycle ls complete.