Motorola MBP35BL - Manual (Page 9)

Getting started 9
ENGLISH
1. Loosen the screw in a counterclockwise direction using a small
screwdriver. Remove the battery cover.
2. Insert the wire tab of the rechargeable battery pack into the contact
slot as shown above and fit the battery pack into the compartment.
3. Close the battery compartment and tighten the screw in a clockwise
direction.
4. Press and hold
p
to switch ON the parent unit.
- It will take a few seconds to start up the unit.
5. Press and hold
p
to switch OFF the parent unit.
NOTE
When the battery level is low, the power LED will turn orange and will
flash. Charge the battery pack for at least 15 hours before using on
battery power only.
NOTE
When the unit is powered up with either the power adapter or using the
rechargeable battery pack, the LED will light up in green. If both the
power adapter and rechargeable battery pack are used, the LED will light
up in red.
2.4 Parent unit power supply
1. Connect the small plug of the power adapter to the parent unit and
the other end to the mains socket (230V/50Hz).
NOTE
Only use the enclosed power adapter (6V DC / 800mA).