Registration – Motorola MBP35BL User Manual

Page 10

Getting started

2. Press and hold

to switch ON the parent unit. The power LED

will light up in green.

3. Press and hold

to switch OFF the parent unit.

NOTE
Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit. When the VOX mode
is on, the screen will turn off after a few seconds if the sound near the
baby unit drops below the Voice Activation threshold level of the unit.
When there is no connection or out of range, the

icon on the LCD

display will flash and the parent unit will beep continuously. Move the
parent unit closer to the baby unit until the link is re-established.

2.5

Registration

The Baby monitor is pre-registered to your Parent Unit. You do not need
to register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the
procedure below:
1. Switch off the Baby Unit
2. Press and hold the

button on the Parent Unit until

appears on the display screen.

3. Then press the

button to confirm the selection and enter the

registration mode.

.....

will appear on the screen for up to 15

seconds.

4. Switch the Baby Unit ON to enter the registration mode. The power

LED on the Baby Unit flashes quickly for approximately 3 seconds.

The registration is completed when

.....OK

appears and then the

video captured by Baby Unit’s camera appears on the display screen of
the Parent Unit.
If the registration fails then

.....X

appears and then both the Parent

and Baby Unit return to normal mode.
NOTE
If a particular Baby Unit had been registered already, registering this
current Baby Unit again will over-write the old registration.