Motorola MBP35BL - Manual (Page 17)

Help 17
ENGLISH
7. Help
Display
No display
• Try recharging or replacing the batteries.
• Reset the units. Unplug the units’ electrical power, including the
batteries and both mains adapters, then plug them back in.
• Is the unit turned on?
Press and hold
p
on the parent unit to turn it on.
Is the VOX mode on?
• Turn the VOX off (see “4.4 Voice Activation”) to keep the screen on
continually.
Registration
If the baby unit has lost its link with the parent unit
• Try recharging or replacing the batteries.
• If the baby unit is too far away it may be going out of range, so move
the baby unit closer to the parent unit.
• Reset the units by unplugging the units’ batteries and mains electrical
power. Wait for around 15 seconds and plug it back in again. Allow up
to one minute for the baby unit and the parent unit to synchronise.
• See “2.5 Registration” if there is a need to re-register the units.
Interference
Noise interference on your parent unit
• Your baby and parent units may be too close. Move them further away
from each other.
• Make sure there is at least 1 metre between the 2 units to avoid
feedback howling.
• If the baby unit is too far away it may be going out of range, so move
the baby unit closer to the parent unit.
• Make sure the baby and parent units are not near other electrical
equipment, such as a television, computer or cordless/mobile telephone.