Memorex MVP0028 - Manual (Page 6)

6
SAFETY PRECAUTIONS (CONTINUED)
• For a car equipped with air bags, be sure to follow the manufacturer’s instructions whenever
performing any electrical wiring work. Incorrect wiring can cause the air bag system of a car to
malfunction.
• Never cut the insulation from the power supply lead in an attempt to draw power for another device.
Doing so can overload the current capacity of the lead, creating the danger of fire and
electric shock.
• For proper installation and wiring special technical knowledge is required. If you have any
doubts about where to position or how to install components, contact the retailer where you
purchased the product, your automobile dealership, or an automotive service provider. Note
that you will be charged separately for installation work.
• Use all of the components that come with this product only as directed. Improper use of
components can damage interior components or result in improper anchoring of compo-
nents, which creates the danger of accident and personal injury.
• Improper installation creates the danger of fire and accident.
• Take care so wires are not pinched between chassis parts, by screws, or by the seat as it
slides on its rails, etc. Such conditions can cut wires and cause shorts, creating the danger
of accident, electric shock, and fire.
• Avoid installation in areas subject to strong vibration and areas where secure anchoring
cannot be achieved. Components installed in such areas can work loose, creating the
danger of accident and personal injury.
• Never install the VCP on the dashboard or in any other location where it obstructs forward
vision.
• Never attach the stand to the roof of your car. Doing so creates the danger of the VCP
falling down.
• Never attach the stand to a sharply angled surface or to a surface that causes the VCP to
face downwards. Such installation can cause the VCP to fall.
• Be sure to turn the ignition key of the car to the “OFF” position before connecting or disconnecting
wires and cables. Failure to do so creates the danger of electric shock and personal injury.
INSTALL THE VCP IN YOUR CAR
• Never watch the VCP or try to adjust settings while driving. Doing so creates the danger of
traffic accident. Before operating the VCP, be sure to stop the car in a safe area.
• Never install the unit on the dashboard or in any other location where it obstructs forward
vision. Items that obstruct forward vision in a motor car may be illegal.
DRIVING SAFETY
4C61501A E/COV-07 9/13/01, 2:19 PM 6