Motorola MPC5200 - Manual (Page 10)

4 KADAK KwikNet MPC5200 FEC Device Driver
4. Configuring the Device Driver
You must define the KwikNet device driver attached to each network interface that your
application supports. If you call KwikNet procedure kn_ifadd() to dynamically add a
network interface at runtime, you must provide the device driver definition as a parameter
in the call.
If you specify a prebuilt network, you must define its device driver by using the KwikNet
Configuration Manager to edit your KwikNet Network Parameter File. The driver
parameters are edited on the Networks property page. The layout of the window is shown
below. Follow the directions provided in Chapter 2.5 of the KwikNet TCP/IP Stack User's
Guide.
The numeric device driver parameters used to configure the operating characteristics of
the
KwikNet MPC5200 FEC Ethernet Device Driver are defined in Appendix A.