Motorola 68HC12BC32 - Manual (Page 18)

18
TABLE 3. D-Bug12 Monitor Commands
ASM Single line assembler/disassembler
Disassemble next instruction
<.> Exit assembly/disassembly
BAUD Set communications rate for the terminal
BF
[] Fill memory with data
BR [ Set/Display user breakpoints
BULK Erase entire on-chip EEPROM contents
CALL [ Call user subroutine at
DEVICE [
[ display/select/add target device
EEBASE Set base address of on-chip EEPROM
FBULK Erase entire target FLASH contents
FLOAD [] Load S-Records into target FLASH
G [ Begin/continue execution of user code
GT Set temporary breakpoint at
HELP Display this D-Bug12 command summary
LOAD [] Load S-Records into memory
MD [] Memory Display Bytes
MDW [] Memory Display Words
MM Modify Memory Bytes
Examine/Modify next location
or <=> Examine/Modify same location
<^> or <-> Examine/Modify previous location
<.> Exit Modify Memory command
MMW Modify Memory Words (same subcommands as
MM)
MOVE
Move a block of memory
NOBR [ Remove One/All Breakpoint(s)
RD Display all CPU registers
REGBASE Set base address of I/O registers
RESET Reset target CPU
RM Modify CPU Register Contents
STOP Stop target CPU
T [] Trace instructions
UPLOAD
S-Record Memory display
USEHBR Use Hardware Breakpoints
VERF [] Verify S-Records against memory contents
Set register contents
Register Names: PC, SP, X, Y, A, B, D
CCR Status Bits: S, XM, H, IM, N, Z, V, C